@@ -116,6 +116,6 @@ Below we show a new design incorporating this magnet change and rotating the ICs
I did a quick 3D print of this design to check clearance and assembly issues. The flexure looks great (albeit obviously too compliant in the photopolymer material).
<imgsrc='v2/eden-prototype.png'width=310px>
<imgsrc='v2/eden-prototype.jpg'width=310px>
Next task is designing the AS5013 board and its connection to the main board on the end of the cylinder. I'm thinking of using the four position Mill-Max spring contact connectors to save space over a wired connector. It should make a solid electrical connection for the I2C lines, power, and ground, while allowing room for fine adjustments of the sensor carrier boards. It's going to be a tight fit getting around the corner.
